B102 is disconnected from the other labs physically. It is required that we run our own network inside the lab. In this case we must connect B102 to the main lab (B111). We don't have access to the networking room so we cant run cable through there or use existing infrastructure to meet our requirements. I have run a cable through from the door of B102 to through the cable trays down along the floor past the elevators up the wall and through a cable tray to the pipe to the Electronics/Mech shop. The spool is outside the door of B102 because there is no way to get a cable into B102. The old cable through hole was covered up when they did the lab renovations. We will need a new hole which may be hard because B102 is a laser lab so we have to do it safely. See the attached pictures to see the cable run.