[Jeff, Daniel]

We attached a 10" to 6" reducer flange to the front face (where the laser enters) to the Laser Filter Cavity (LFC) Input cubed and tightened the screws to 34 Nm. We attached a 6" to 2x2.75" reducer flange to this reducer flange, and I tightened the screws to 34 Nm using the new 2" torque adaper extension tool. This new tool doesn't affect the torque amount if it's perpendicular to the handle.

I then attached a 2.75" blank flange to the unused port on the 6" to 2x2.75" reducer flange and tightened the screws to 14 Nm.