After refitting the base of the drill press, I attached it to the table with the previously purchased hardware. I made special care not to over tighten it and secured the bolts with loctite. I also was able to drill the last hole through the table for the vice. It goes through the metal frame. I also realized that that table top is not attached to the legs in the proper way. It seems like whoever built it just used silicone to stick them together. There are holes for screws to attach the table to the table top. They should have done that. It seems like all the tables have this problem. It is possible for the vibrations from the drill press or movement from the vice to separate the table top from the legs. They should come back and fix it.